The exhaust pipe on the drivers side should be bank two or just go by cylinder #2, it will be the first oxygen sensor in that pipe. this would be bank two sensor one. will be the sensor before the cat.
Welcome New User! ( Create Account | Sign In )
| You are here: Home Categories Automobiles 2003 chrys. 300m special 3.5 l ho eng. obd fault ... |
Question
Submitted 61 days ago...
Answers
This Question was awarded 58 days ago therefore you can no longer post an Answer. However you may post a comment below.
Add A Comment
Related Questions
Related Questions
What does this code mean on a lexus sc 430 2002
Code is po155 o2 sensor heater bank 2 sensor 1
View Question
Crankcase position sensor
Where can i locate the crankcase position sensor on 2003 chevrolet suburban or refer me to...
View Question
Diagram for 2004 suzuki aerio that has the transmission range sensor
My a/t started to not shift properly it only happens when i turn the headlights on. the check...
View Question
Location oxygen sensor 1 bank 2 mazda 626 6 cylinder
Can i change oxygen sensor1 bank 2 in home garage without special tool. mazda 626, 1999, 6...
View Question
I have a 1997 chev. g20 a ckt range/perf tps pedal position sensor , idel control system rpm high and 02 bank 1-sensor 1&2 no...
Is there anything else i can check that may cause this.
View Question
2003 saab po455 fault code
Above mentioned car engine fault light comes on every few days. fault code is evaporative...
View Question
What can i do?
What sensors do i need when the code reads,running to rich ,missfire on number one, bank two.the...
View Question
What does the oxygen sensor do
The engine check light comes on in the vehicle. its a toyota townace 2003. it was checked...
View Question
Loss of power
2003 olds alero, loss of power,bucks on partial rapid
throttle. replaced inboard co2 sensor,...
View Question
About |
FAQs |
Contact Us |
Member Agreement |
Privacy Policy |
Site Map |
Partners
Copyright © WebAnswers 2009. All rights reserved.
