Welcome New User! ( Create Account | Sign In )

Maximize

You are here: Home Categories Autos & Transportation Distributer on 1986 olds cuttlass ciera

Previous | Next

1986 olds It keeps wanting to flood out ,and was backfiring from the carb , what might be the problem?

I need a vacuum line diagram for a 1989 olds cuttlass Im not sure if all my vacuum lines are right

How do you replace the thermostat of a 1996 olds ciera v6 3.1l engine? How do you replace the thermostat on a 1996 olds ciera v6 3.1l engine?

Turn signal relay Where is the turn signal relay located on a 1986 olds ciera

On my 94 cutlass ciera olds it starts running really rough at 65 mph and acts like it wants to die what is the problem and ho... At 65 mph the car runs rough and acts like it wants to die what is the problem and how do...

Congratulations!

Spout936

Contributor (123)

Spout936 answer was awarded and will earn ongoing royalties from this thread.

How This Works?

Get paid for participating

Ask questions - It's FREE Get answers within minutes.

Fun, fast and easy. Share your opinions with our community. Earn money for answering. See how.

Find more related questions to Distributer on 1986 olds cuttlass ciera

Question

Submitted 610 days ago...

Tugrik711

New User (4)

Distributer on 1986 olds cuttlass ciera

How do you get to the distributor on a 86 olds w/air , its in the back of the motor by the firewall . its a 4cylinder motor . is there a way to get to it from the top side or you have to get at it from the underside ?

Share | Abuse |

Answers

Answer 1 / 3 - Submitted 610 days ago...

Rick_

Expert (685)

from the top : you might have to take off the air filter for the carb before you can get to it

Share | Link | Abuse

Answer 2 / 3 - Submitted 610 days ago...

Tugrik711

New User (4)

Can I pull the front motor mount and pull the motor forward for more room to work?

Share | Link | Abuse

Awarded Answer (What’s This?)

Answer 3 / 3 - Submitted 610 days ago...

Spout936

Contributor (123)

I have often disconnected the master cylinder by removing the (2) mounting nuts and leaving the brake lines connected pulled the whole master cylinder unit forwards of of the brake booster..
This can give you a more room to get your body in position and a better angle of visibility in seeing below the manifold and this takes only takes a minute or so to do.

The view of the distributor from the bottom is not very good one all and you would be lucky to get an arm and hand one hand up in there and be able to see what you are doing at the same time. I find working from the bottom to be very frustrating. It also helps to have a very good light source down in there too and not just a flash light. Sometimes I sneak an extra light in from the left side of the engine the more light the better.
Good Luck!

Share | Link | Abuse

This Question was awarded 606 days ago therefore you can no longer post an Answer. However you may post a comment below.

Add A Comment

Related Questions

Where is thr horn relay for a 1995 oldsmobile cutlass ciera sl

Where is the horn relay for a 1995 olds cutlass ciera sl

Open | Category: Autos & Transportation | 0 Replies

Why doesnt my 94 chevy s10 have any spark in the coil and distributer?

There is no spark in the coil or distributer. i put a new coil in it. and it does the same thing.

Open | Category: Autos & Transportation | 1 Reply

Who replaced citibank as distributer of retiree pensions

Lucent pensions in August 2008 were distributed by Citibank. The following distribution was made by an unnamed company in Ma. What company or banking firm is that?

Open | Category: Finance & Investing | 0 Replies

93 cutlass ciera none of the power windows work

motor is good, wiring has 12 volts at motor when switch is pressed,but motor won,t run. motor will run when hooked direct to battery

Open | Category: Maintenance & Repairs | 5 Replies

Will 403 olds engine mounts fit a 350 olds?

Open | Category: Car Makes | 2 Replies