| You are here: Home Categories Automobiles Gas pedal position makes no differance to eng rpm |
Submitted 295 days ago...
Answer 1 / 2
Submitted 295 days ago...
Answer 2 / 2
Submitted 294 days ago...
Answer This Question Now
If your Answer is chosen as the “accepted” answer, you will earn ongoing royalties on
this thread.
Simply type your Answer in the box below and post your answer.
That van its a '98 pontiac transport and i did the tune up, when i tried to start that van it won't start but if i press the gas pedal and leaved press for like 10 seconds after i tried to start that van...
Couple of months ago, check engine light came on. Mechanic said Cam Position Sensor. Replaced it. Now, sporadically, check engine light comes on and the car won't start. Sounds like normal start but doesn't...
When you step on the break pedal, it is very difficult, but there is hardly any breaks at all. what might be the problem? when pushing down on the pedal, the seem to be a lot of pressure! thanks,joe
That van its a '98 pontiac transport and i did the tune up, when i tried to start that van it won't start but if i press the gas pedal and leaved press for like 10 seconds after i tried to start that van...
That van its a '98 pontiac transport and i did the tune up, when i tried to start that van it won't start but if i press the gas pedal and leaved press for like 10 seconds after i tried to start that van...
This Question has not been awarded yet.
