I checked my all data and there is no removal procedure listed or illustrated. Many times the whole mechanism has to be removed to gain access. The mechanism may be riveted to the door itself and if is the csse the pop rivet heads will have to be drilled off. There are special long pop rivets for this and the rivet gun for installing them is special also. Nuts and bolts most times will interfere with the mechanism so hence the use of rivets. Usually the window is disconnected pushed up to a closed position and held in place with a rubber or wood wedge shoved down between the glass and the door body. This will keep the glass up while the mechanism is being removed. Sometimes the door metal door panel has to be cut and pried down a bit to get the unit out and pushed back up after reinstalling the mechanism. Hope this helps you some.
Welcome New User! ( Create Account | Sign In )
| You are here: Home Categories Automobiles How do I change the window motor on 1998 toyota 4 ... |
Question
Submitted 262 days ago...
Answers
This Question was awarded 257 days ago therefore you can no longer post an Answer. However you may post a comment below.
Comments
Comment 1 / 1
Submitted 257 days ago...
Add A Comment
Related Questions
Replace window motor
When replacing the right door window motor on a 99 dodge caravan the spool of wire came unravelled from the plastic wheel that's part of the motor that controlls the window up and down. I can't seem to...
I want the cost (parts and labor) to replace the drivers front door window motor.
I have a 1997 Pontiac Grand Am SE/ The window keeps sticking when I try to close it. I have to drive and push to window control. It goes up a little at a time. Sometimes it takes longer. Heaven forbid I should...
Related Questions
Replace window motor
When replacing the right door window motor on a 99 dodge caravan the spool of wire came unravelled...
View Question
Eclipse car window
My window fell down into my door. took off the door panel to see the problem. sheet of metal...
View Question
I want the cost (parts and labor) to replace the drivers front door window motor.
I have a 1997 pontiac grand am se/ the window keeps sticking when i try to close it. i have...
View Question
1995 honda civic cx motor swap
I have a 1995 honda civic cx with a 16 valve 1.5 d15b7 & 5-speed trans. my motor is bad &...
View Question
Setting lifters
I have a 77 toyota land cruiser fj40. haven't taken anything apart on the motor. not sure...
View Question
How do you take the inside shell of the front drivers door off?
I have a 2002 buick rendevious that i need to get the front inside shell of the door off to...
View Question
Will not bring yhr 1 spark plug up to tdc cause for the motor to lock up and bend the head valves
Had to change water pump on a 1995 chrysler cirrus lxi so i took the timing belt covers off...
View Question
Why won't the passenger side window roll up?
I can hear the motor but the window won't go up on a 96 mercury grand marquis.
View Question
99 chev. monte carlo ls 3.1l window problems
Passenger window wont go down, is there a fuse or a way to test the motor?
View Question
How does the wiring go from the harness to the motor
I have a 1983 mustang gt 5.0 302 5 speed i need to know where the 3 wire plug goes from the...
View Question
About |
FAQs |
Contact Us |
Member Agreement |
Privacy Policy |
Site Map |
Advanced Search
Copyright © WebAnswers 2008. All rights reserved.
