Welcome New User! ( Create Account | Sign In )

Maximize

You are here: Home Categories Autos & Transportation How do you remove a bolt off of the crank shaft for a 2002 suzuki xl7

Previous | Next

2003 suzuki xl7 body repair Lve hit an icy snow bank.cracked the front bumper and grill of my 03 suzuki xl7, it will need...

Do i have to remove the crank shaft pulley to replace water pump on 95 nissan quest? What is the replacement procedure for changing a water pump on a 95 nissan quest?

Will a stock 1978 302 ford crank shaft (with stock 1978 vib dampner and flex plat installed), bolt into a stock 1986 ford 302... I have a factory stock 78 ford 302 crank complete with vib dampner and flex plate. i want...

I've got a 2002 silverado 4.3l v-6 and it will not crank or turn over. I have replace spark plugs and wires. the crank sensor, the ignition module and ignition...

We need to know where the crank shft sensor is in my nissan I have a nissan altima 2003.we know the crank shaft needs replacing.we just ca't find...

Congratulations!

Rick_

Expert (685)

Rick_ answer was awarded and will earn ongoing royalties from this thread.

How This Works?

Get paid for participating

Ask questions - It's FREE Get answers within minutes.

Fun, fast and easy. Share your opinions with our community. Earn money for answering. See how.

Find more related questions to How do you remove a bolt off of the crank shaft for a 2002 suzuki xl7

Question

Submitted 571 days ago...

Akan415

New User (1)

How do you remove a bolt off of the crank shaft for a 2002 suzuki xl7

How do you remove the bolt from the crank shaft on a 2002 suzuki xl7

Share | Abuse |

Answers

Awarded Answer (What’s This?)

Answer 1 / 1 - Submitted 570 days ago...

Rick_

Expert (685)

This bolt is torqued to about 300 foot pounds you need to lock the engin up so it wont trun over when you try to break this bolt loose and use a good socket and pull handle with a long breaker bar attached to the pull handle , or get a impack wrench with a 1 inch drive that delivers 300 to 400 foot pounds of torque

Share | Link | Abuse

This Question was awarded 528 days ago therefore you can no longer post an Answer. However you may post a comment below.

Add A Comment

Related Questions

How do I remove the water pump from 1991 Isuzu Trooper?

Do I have to remove the crank shaft pulley?

Open | Category: Autos & Transportation | 0 Replies

2001 galant balance shaft timing belt

Balance shaft timing belt broke. replaced crank shaft position sensor and belt. drove 1/2 mile and car died. sounds like timing issue. car turns over and tries to start, but doesn't. matched timing marks, single...

Open | Category: Autos & Transportation | 0 Replies

I need to remove the crank pully with out a gear puller can it be done?

It is a 1996 dodge stratus 2.4 litre 4 cylinder

Open | Category: Autos & Transportation | 1 Reply

Has the 5 hp down shaft oil pan have a bearing or busion for the crank to go through?

Has the 5 hp shaft oil pan have a bearing or busion for the crank to go through?

Open | Category: Lawn & Yard Equipment | 1 Reply

What would case a crank case bolt to break

Car

Open | Category: Autos & Transportation | 1 Reply