If your Answer is chosen as the “accepted” answer, you will earn ongoing royalties on
this thread.
Simply type your Answer in the box below and post your answer.
Welcome New User! ( Create Account | Sign In )
| You are here: Home Categories Automobiles How to install a new heater control valve or blend... |
Question
Submitted 92 days ago...
How to install a new heater control valve or blend door in a 2001 Windstar
I have heat in the rear but not in the front. I believe the heater control valve or "blend door" that is controlled by a small motor with plastic gears is stuck in the cold position. But, I don't know how to access it or replace it.
Answers
No Answers have been posted yet.
Answer This Question Now
Related Questions
Related Questions
1998 ford expedition heater issue
Where is the blend door located and what is the easiest way to access it. my heater works...
View Question
Blend door actuator 1986 lincoln town car
How can i test and replace the blend door actuator to see if this is why my ac stops working...
View Question
Blend door fault
02 chevy trailblazer. the blend door that controls air goes defrost, vent, feet or both. when...
View Question
I need an illustration of the blend door actuator on a 2001 ranger
Also i would like to know what is the correct procedure of r&r on this item.
View Question
I have a 9gpm@1000 psi hydraulic pump (pto driven).
The fluid leaves the pump and runs into and out of a two lever vavle .the out fluid runs through...
View Question
Where can i get a diagram of the vacuum lines that go to the heater control in a 1985 chevy truck
The heater/defroster/ & ac control in the dash. all of the vacuum lines have been pulled off....
View Question
I have a 2003 chev venture van with duel heating controls for front and back. the heater works and blows in the back but not...
Heater stopped working in the front of my chev van. blower still works in the back but nothing...
View Question
Heater only works on defrost
Replaced heater core on my 98 dodge dakota. now it only blows heat thru the defrost vents....
View Question
Where is o2 sensor for heater located on 2001 lexus is300?
There are 3 o2 sensors on this vehicle exhaust, catalytic but i need to replace the other...
View Question
Valve adjustment for nissan sentra 2001 1.8l
I would like the clearence and tourque numbers for adjusting valves on a 2001 nissan sentra...
View Question
This Question has not been awarded yet.
About |
FAQs |
Contact Us |
Member Agreement |
Privacy Policy |
Site Map |
Partners
Copyright © WebAnswers 2009. All rights reserved.
