Make sure you didnt knock anything loose when you replaced the wires and plugs, it sounds like a vaccuum leak, make sure the intake boot is tight around the throttlebody, and all of the vaccuum hoses are where they are supposed to go.
Welcome New User! ( Create Account | Sign In )
| You are here: Home Categories Autos & Transportation Maintenance & Repairs my 1996 ford taurus RPM gage is moving while stop sign |
This Question has not been awarded yet.
Question
Submitted 21 days ago...
Answers
Answer This Question Now
my 1996 ford taurus RPM gage is moving while stop sign
If your Answer is chosen as the “accepted” answer, you will earn ongoing royalties on
this thread.
Simply type your Answer in the box below and post your answer.
Related Questions
1996 Taurus transission
I have a 1996 Taurus . When Idling it will not go into gear until I get the revs up to 1800- 2000 rpm. I heard this may be a speed sensor. Might you agree and is it an expensive repair?
Engine diagram for 98 ford taurus
My car is leaking coolant ... the temp gauge is not moving either up or down... could this be the water pump..or is it more likely to be a hose problem
My 2.9 ford ranger wont rev over 3000 rpm
Starts fine, idles at 1500 rpm, new fuel pump and filters.
2000 ford taurus 3.0
Car was spinning over before the heads were replaced, every thing was put back in place and we even replaced the starter relay, brain box, transmission range sensor and fuel pump. what could it be. car does have...
Overview |
FAQs |
Contact Us |
Member Agreement |
Privacy Policy |
Site Map |
Partners
Copyright © WebAnswers 2009. All rights reserved.
