Take fuel line off close to intake and pump some gas into a clean, dry glass container. Let it settle a while and look in bottom to see if any water settled. The water is too thick to get through the injectors.
Welcome New User! ( Create Account | Sign In )
| You are here: Home Categories Autos & Transportation What wood cause engine to stall on acceleration in or out of gear |
This Question has not been awarded yet.
Question
Submitted 533 days ago...
Answers
Answer 2 / 3 -
Submitted 490 days ago...
You probibaly have a bad fule presher regulater it is spider injected. to tell that you will have to take the intack off and look at the regulater to see if it has been leekin out the little whole . if it has then buy the whole it will look dried up and will have a shinny look if so replase the regulater....
Answer 3 / 3 -
Submitted 490 days ago...
You might also have a bad tps.. or Iac check thoes also but ill almost bet its the regulater.
Answer This Question Now
What wood cause engine to stall on acceleration in or out of gear
If your Answer is chosen as the “accepted” answer, you will earn ongoing royalties on
this thread.
Simply type your Answer in the box below and post your answer.
Related Questions
Car problem rapid acceleration
I recently had engine work done on my nissan quest, knock sencor crank senson, etc. Since then, on three occasions I experienced rapid acceleration with the van with little effect when applying the brakes. I...
How do I time the camshaft gear to the crankshaft gear on a Craftsman 6.5 HP OHV engine Mod #143.986501?
How do I time the camshaft gear to the crankshaft gear on a Craftsman 6.5 HP OHV engine Mod #143.986501?
Rear gear ratio
I have a 1999 chevy blazer zr2 with a 4.3 vortec (obviously) I have modified my engine to the point that it puts my drive train in danger and I need to upgrade my transmission, driveshaft, u-joints, and differentials...
Overview |
FAQs |
Contact Us |
Member Agreement |
Privacy Policy |
Site Map |
Partners
Copyright © WebAnswers 2009. All rights reserved.
