How do you frame a pyramid roof?

Start by nailing common rafters on one side of the ridge at each end. Now raise the ridge
and nail two rafters on the other side of the ridge opposite the first two rafters. Once
this is done, push the ridge up so the birdsmouth cuts pull in tight to the walls on each
side of the building. These rafters can now be nailed to the wall in their corresponding
locations in relation to the ridge. Now nail the two common rafters to the center of the end
walls and to the ends of the ridge board. This will lock the ridge in its exact location.
The rest of the common rafters can be nailed to the wall and ridge board.
The next parts to be installed are the four hip rafters. These are nailed on the outside
corners of the buildings walls and in the intersection made by the end and first common
rafter where they meet at the ridge. With the hips and common rafters in place, its easy to
see why this makes for such a strong and solid roof.

With the hip rafters in place the jack rafters can be installed. Before nailing on the first
jack rafter, a string must be run from the plumb cut on the hip rafter to just above the
birdsmouth. This can be done by driving a nail in the center of the hip at the above mentioned
locations. Tie the string to one nail, pull it tight, and secure it to the other nail. This
is to ensure the hip rafter stays straight during the jack rafter installation. As the jacks
are nailed on, the string should be kept at the center of the hip. To help keep the hip
rafter straight, the jack rafters should be nailed on in pairs, first one side of the hip,
then its mate on the other. This process is continued all the way down the the hip rafter
till all jack rafters are installed on both sides of the hip. Remove the string and repeat
this procedure on the remaining three hip rafters to complete the framing of the roof.
Collar ties and fascia boards will need to be installed before the roof can be sheathed, but
these are the basic steps to framing a hip roof