Submitted 329 days ago...
HD TV
I have a 37 inch flatscreen by Magnavox (about a year old). It works great when it's on, but the last couple of days I have trouble turning it on. The power light will come on like normal, but then will flash a couple times and go off and the TV won't come on. I've tried the button on the set and the remote and both do the same. It will come on eventually, but it takes a few minutes. What could the problem be? Simple fix?
Answer 1 / 4
Submitted 329 days ago...
Answer 2 / 4
Submitted 328 days ago...
Your gonna have to take it off the wall, on the back you will see numerouse little holes, one should be marked "reset" you will need a long pointy tool to get to the button in there, a toothpick is not long enough, I use the nut pick tool that comes with a nut cracker set ;) If that doesn't work, your power chip may have gone bad so you should check your warrenty, there should be a phone number on the back of your tv you can call, mine went out after the warrenty was up and is cost me $130 to have it replaced, much cheaper than a new tv. Hope this helps.
Answer 4 / 4
Submitted 328 days ago...
This Question was awarded 325 days ago therefore you can no longer post an Answer. However you may post a comment below.
Comment 1 / 1
Submitted 325 days ago...
Add A Comment
Have a magnavox 32md251d/37 dvd hdtv where when plugged in makes the green led flash off and on and the lcd screen is doing the same. I feel the problem is in the power supply. Anybody seen this and am i barking...
We are installing two 4160v three conductor #500 MCM Armoured cables from a 5500 HP motor terminal box located in a Pumphouse (indoors). These cables will be run in two 6 inch rigid PVC conduits and stub up approx....
I have a Cannon BJC-610 printer that works great except it no longer feeds paper from the tray. I think the rollers have gotten dried out. I beleve replacing these rollers will restore my printer for many more...
